Shopping Cart
no products
DOG AUTOBETT -  FITTING 
 

The dog is not connected to the bed, but to the vehicle directly using the CLICK&SAFETY. Your dog's leash should be adjusted to the length suitable for allowing your dog to be freely cushioned by the case wall when you brake hard, but not be thrown out of the system. All lengths can be adjusted individually.


The CLICK&SAFETY is attached to the luggage mounts in the boots.



You then install the DOG CAR BED and pass the CLICK&SAFETY through the openings. Make sure that the carabiner strap it connected to the CLICK&SAFETY in the case wall.



Now your dog can travel in safety and your car stays clean. We recommend a harness for your dog's safety. Since the concept is only to prevent the dog from leaving the system, attaching his collar should suffice in theory. If your car rolls over or similar, then the dog's weight hangs from its neck, which we don't think is very good, although this is what the photos clearly portray. This is meant solely as information—how you proceed at this point is very much up to you.




 
 
DOG SAFETYSEAT / DOG BACKSEAT  FITTING 

 

The dog is not connected to the bed, but to the vehicle directly using the CLICK&SAFETY. Your dog's leash should be adjusted to the length suitable for allowing your dog to be freely cushioned by the case wall when you brake hard, but not be thrown out of the system. All lengths can be adjusted individually.
 

Feed the strap around the rear seat backrest or backrest. You use the entire backrest with DOG BACK SEAT Size L. Ensure that the rear seat backrest clicks into place properly again.




You also attach the carabiner belt connector to the side case wall with the DOG SAFETY SEAT. Measure the length again so that your dog is freely absorbed by the case wall when braking hard, but cannot be thrown out of the system.



 
We manufacture customized sizes: +49 (0) 29 21 / 944 762 -0